18-15
Cisco ME 3400 EthernetAccess Switch SoftwareConfiguration Guide
78-17058-01
Chapter18 Configuring DHCP Feat ures and IP Source Guard Configuring IP Source Guard
IP Source Guard Configuration Guidelines
Note IP source guard is supported only when the metro access or metro IP access image is running on the
switch.
These are the configuration guides for IP source guard:
•You can configure static IP bindings only on nonrouted ports. If you enter the ip source binding
mac-address vlan vlan-id ip-address interface interface-id global configuration command on a
routed interface, this error message appears:
Static IP source binding can only be configured on switch port.
•When IP source guard with source IP filtering is enabled on a VLAN, DHCP snooping must be
enabled on the access VLAN to which the interface belongs.
•If you are enabling IP source guard on a trunk interface with m ultiple VLANs and DHCP snooping
is enabled on all the VLANs, the source IP address filter is applied on all the VLANs.
Note If IP source guard is enabled and you enable or disable DHCP snooping on a V LAN on the
trunk interface, the switch might not properly filter traffic.
•When IP source guard with source IP and MAC address filtering is enabled, DHCP snooping and
port security must be enabled on the interface.
•When configuring IP source guard on interfaces on which a private VLAN is configured, port
security is not supported.
•IP source guard is not supported on EtherChannels.
•You can enable this feature when IEEE 802.1x port-based authentication is enabled.
•If the number of ternary content addressabl e m emo ry (TC AM) entries exceeds the maximum
available, the CPU usage increases.
Enabling IP Source Guard
Beginning in privileged EXEC mode, follow these steps to enable and configure IP sourc e gua rd on an
interface.
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 interface interface-id Specify the interface to be configured, and enter interface configuration
mode.
Step3 no shutdown Enable the port, if necessary. By default, UNIs are disabled and NNIs are
enabled.
Step4 ip verify source
or
ip verify source port-security
Enable IP source guard with source IP address filtering.
Enable IP source guard with source IP and MAC address filtering.