16-9
Cisco ME 3400 EthernetAccess Switch SoftwareConfiguration Guide
78-17058-01
Chapter16 Configuring Optiona l Spa nning-Tree Features Configuring Optional Spanning-Tree Features
To disable the EtherChannel guard feature, use the no spanning-tree etherchannel guard misconfig
global configuration command.
You can use the show interfaces status err-disabled privileged EXEC command to show which switch
NNIs are disabled because of an EtherChannel misconfiguration. On the remote device, you can ent er
the show etherchannel summary privileged EXEC command to verify the EtherChannel configuration.
After the configuration is corrected, enter the shutdown and no shutdown interface configuration
commands on the port-channel interfaces that were mi sco nfigured .
Enabling Root Guard
Root guard enabled on an NNI applies to all the VLANs to which the NNI belongs.
Note You cannot enable both root guard and loop guard at the same time.
You can enable this feature if your switch is running PVST+, rapid PVST+, or MST P.
Beginning in privileged EXEC mode, follow these steps to enable root guard on an interface. This
procedure is optional.
To disable root guard, use the no spanning-tree guard interface configuration command.
Enabling Loop Guard
You can use loop guard to prevent alternate or root ports from becoming designated ports b eca use o f a
failure that leads to a unidirectional link. This feature is most effective when it is conf igured on th e entire
switched network. Loop guard operates only on NNIs that are considered point-to-point by the spanning
tree.
Step4 show spanning-tree summary Verify your entries.
Step5 copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 interface interface-id Specify an interface to configure, and enter interf ac e c on figuration mode. If
the interface is not an NNI, you must enter the port-type nni interface
configuration command before enabling root guard.
Step3 spanning-tree guard root Enable root guard on the NNI.
By default, root guard is disabled on all interfaces.
Step4 end Return to privileged EXEC mode.
Step5 show running-config Verify your entries.
Step6 copy running-config startup-config (Optional) Save your entries in the configuration file.