32-36
Cisco ME 3400 EthernetAccess Switch SoftwareConfiguration Guide
78-17058-01
Chapter32 Configuring IP Unicast Routing
Configuring EIGRP
Configuring EIGRP Interfaces
Other optional EIGRP parameters can be configured on an interfa ce bas is.
Beginning in privileged EXEC mode, follow these steps to configure EIGRP interfaces:
Use the no forms of these commands to disable the feature or return the setting to the default value.
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 interface interface-id Enter interface configuration mode, and specify the Layer 3
interface to configure.
Step3 no shutdown Enable the interface if necessary. By default, UNIs are
disabled and NNIs are enabled.
Step4 ip bandwidth-percent eigrp percent (Optional) Configure the percentage of bandwidth that can
be used by EIGRP on an interface. The default is 50 percent.
Step5 ip summary-address eigrp
autonomous-system-number address mask (Optional) Configure a summary aggregate address for a
specified interface (not usually necessary if auto-summary is
enabled).
Step6 ip hello-interval eigrp autonomous-system-number
seconds (Optional) Change the hello time interval for an EIGRP
routing process. The range is 1 to 65535 seconds. The
default is 60 seconds for low-speed NBMA networks and 5
seconds for all other networks.
Step7 ip hold-time eigrp autonomous-system-number
seconds (Optional) Change the hold time interval for an EIGRP
routing process. The range is 1 to 65535 seconds. The
default is 180 seconds for low-speed NBMA networks and
15 seconds for all other networks.
Caution Do not adjust the hold time without consulting
Cisco technical support.
Step8 no ip split-horizon eigrp autonomous-system-number (Optional) Disable split horizon to allow route information
to be advertised by a router out any interface from which that
information originated.
Step9 end Return to privileged EXEC mode.
Step10 show ip eigrp interface Display which interfaces EIGRP is active on and
information about EIGRP relating to those interfaces.
Step11 copy running-config startup-config (Optional) Save your entries in the configuration file.