26-6
Cisco ME 3400 EthernetAccess Switch SoftwareConfiguration Guide
78-17058-01
Chapter26 Configuring System Message Logging
Configuring System Message Logging
is returned. Therefore, unsolicited messages and debug command output are not interspersed with
solicited device output and prompts. After the unsolicited mes sag es ap pear, the co nsol e a gain di sp lays
the user prompt.
Beginning in privileged EXEC mode, follow these steps to configure synchronous logging . This
procedure is optional.
To disable synchronization of unsolicited messages and debug output, use the no logging synchronous
[level severity-level | all] [limit number-of-buffers] line configuration command.
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 line [console | vty] line-number
[ending-line-number]Specify the line to be configured for s ync hro nou s log ging of
messages.
•Use the console keyword for configurations that occur through
the switch console port.
•Use the line vty line-number command to specify which vty
lines are to have synchronous logging enabled. You use a vty
connection for configurations that occur through a Telnet
session. The range of line numbers is from 0 to 15.
You can change the setting of all 16 vty lines at once by entering:
line vty 0 15
Or you can change the setting of the single vty line being used for
your current connection. For example, to change the settin g for vty
line 2, enter:
line vty 2
When you enter this command, the mode changes to line
configuration.
Step3 logging synchronous [level [severity-level |
all] | limit number-of-buffers]Enable synchronous logging of messages.
•(Optional) For level severity-level, specify the message severity
level. Messages with a severity level equal to or higher than this
value are printed asynchronously. Low numbers mean greater
severity and high numbers mean lesser severity. The def ault is 2.
•(Optional) Specifying level all means that all messages are
printed asynchronously regardless of the severity level.
•(Optional) For limit number-of-buffers, specify the number of
buffers to be queued for the terminal after which new messages
are dropped. The range is 0 to 2147483647. The default is 20.
Step4 end Return to privileged EXEC mode.
Step5 show running-config Verify your entries.
Step6 copy running-config startup-config (Optional) Save your entries in the configuration file.