Cisco Systems ME3400G2CSA Default RIP Configuration, Configuring Basic RIP Parameters

32-19
Cisco ME 3400 EthernetAccess Switch SoftwareConfiguration Guide
78-17058-01
Chapter32 Configuring IP Unicast Routing Configuring RIP
These sections contain this configuration information:
•Default RIP Configuration, page 32-19
•Configuring Basic RIP Parameters, page 32-19
•Configuring RIP Authentication, page 32-21
•Configuring Summary Addresses and Split Horizon, page 32-21
Default RIP Configuration
Table32-4 shows the default RIP configuration.
Configuring Basic RIP Parameters
To configure RIP, you enable RIP routing for a network and optionally configure other parameters.
Table32-4 Default RIP Configuration
Feature Default Setting
Auto summary Enabled.
Default-information originate Disabled.
Default metric Built-in; automatic metric translations.
IP RIP authentication key-chain No authentication.
Authentication mode: clear text.
IP RIP receive version According to the version router configuration command.
IP RIP send version According to the version router configuration command.
IP RIP triggered According to the version router configuration command.
IP split horizon Varies with media.
Neighbor None defined.
Network None specified.
Offset list Disabled.
Output delay 0 milliseconds.
Timers basi c •Update: 30 seconds.
•Invalid: 180 seconds.
•Hold-down: 180 seconds.
•Flush: 240 seconds.
Validate-update-source Enabled.
Version Receives RIP Version 1 and 2 packets; sends Version 1 packets.