Cisco Systems ME3400G2CSA - page 579

30-42
Cisco ME 3400 EthernetAccess Switch SoftwareConfiguration Guide
78-17058-01
Chapter30 Co nf iguring QoS
Configuring QoS
Use the no form of the appropriate command to dele t e a policy map or table map or remove an as s igned
CoS, DSCP, precedence, or QoS-group value.
This example uses a policy map to remark a packet. The first marking (t he set command) applies to the
QoS default class map that matches all traffic not matched by class AF31-AF33 and sets all traffic to an
IP DSCP value of 1. The second marking sets the traffic in classes AF31 to AF33 to an IP DSCP of 3.
Switch(config)# policy-map Example
Switch(config-pmap)# class class-default
Switch(config-pmap-c)# set ip dscp 1
Switch(config-pmap-c)# exit
Switch(config-pmap)# class AF31-AF33
Switch(config-pmap-c)# set ip dscp 3
Switch(config-pmap-c)# exit
Switch(config-pmap)# exit
Switch(config)# interface fastethernet0/1
Switch(config-if)# service-policy input Example
Switch(config-if)# exit
Step3 class {class-map-name | class-default} Enter a class-map name or class-default, and enter policy-map class
configuration mode.
•For class-map-name, specify the name of the class map.
•Enter class-default to match all unclassified packets.
If you enter a class-map name, you must have already created the class
map by using the class-map global configuration command.
Step4 set cos {cos_value | cos [table
table-map-name] | dscp [table
table-map-name] | precedence [table
table-map-name]}
or
set [ip] dscp {dscp_value | cos [table
table-map-name] | dscp [table
table-map-name] | precedence [table
table-map-name]}
or
set [ip] precedence {precedence_value |
cos [table table-map-name] | dscp [table
table-map-name] | precedence [table
table-map-name]}
or set qos-group value
Mark traffic by setting a new value in the packet, specifying a table map,
or specifying a QoS group.
•For cos cos_value, enter a new CoS value to be assigned to the
classified traffic. The range is 0 to 7.
•For [ip] dscp new-dscp, enter a new DSCP value to be assigned to
the classified traffic. The range is 0 to 63.
•For [ip] precedence new-precedence, enter a new IP-precedence
value to be assigned to the classified traffic. The range is 0 to 7.
•Or you can configure a CoS, DSCP, or IP precedence table and
optionally enter the table name. If you do not enter table table-map
name, the table map default behavior is copy. See the “Configuring
Table Maps” section on page 30-33.
•For qos-group value, identify a QoS group to be used at egress to
identify specific packets. The range is f ro m 0 t o 15 .
Step5 exit Return to policy-map configuration mode.
Step6 exit Return to global configuration mode.
Step7 interface interface-id Enter interface configuration mode for the interface to which you wan t to
attach the policy.
Step8 service-policy input policy-map-name Attach the policy map (created in Step 2) to the ingress interface.
Step9 end Return to privileged EXEC mode.
Step10 show policy-map [policy-map-name
[class class-map-name]] Verify your entries.
Step11 copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose