20-10
Cisco ME 3400 EthernetAccess Switch SoftwareConfiguration Guide
78-17058-01
Chapter20 Configuring IGMP Snooping and MVR
Configuring IGMP Snooping
To disable IGMP Immediate Leave on a VLAN, use the no ip igmp snooping vlan vlan-id
immediate-leave global configuration command.
This example shows how to enable IGMP Immediate Leave on VLAN 130:
Switch# configure terminal
Switch(config)# ip igmp snooping vlan 130 immediate-leave
Switch(config)# end
Configuring the IGMP Leave Timer
Follow these guidelines when configuring the IGMP leave timer:
•You can configure the leave time globally or on a per-VLAN basis.
•Configuring the leave time on a VLAN overrides the global setting.
•The default leave time is 1000 milliseconds.
•The IGMP configurable leave time is only supported on hosts running IGMP Version 2.
•The actual leave latency in the network is usually the configured lea ve time. Ho we ver , the lea ve tim e
might vary around the configured time, depending on real-time CPU load conditions, network delays
and the amount of traffic sent through the interface.
Beginning in privileged EXEC mode, follow these steps to enable the IGMP configurable-leave timer:
Use the no ip igmp snooping last-member-query-interval global configuration command to globally
reset the IGMP leave timer to the default setting.
Use the no ip igmp snooping vlan vlan-id last-member-query-interval global configuration command
to remove the configured IGMP leave-time setting from the specified VLAN.
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 ip igmp snooping
last-member-query-interval time Configure the IGMP leave timer globally. The range is 100 to 5000
milliseconds. The default is 1000 seconds.
Step3 ip igmp snooping vlan vlan-id
last-member-query-interval time (Optional) Configure the IGMP leave time on the VLAN inter face. The
range is 100 to 5000 milliseconds.
Note Configuring the leave time on a VLAN overrides the globally
configured timer.
Step4 end Return to privileged EXEC mode.
Step5 show ip igmp snooping (Optional) Display the configured IGMP leave time.
Step6 copy running-config startup-config (Optional) Save your entries in the configuration file.