28-3
Cisco ME 3400 EthernetAccess Switch SoftwareConfiguration Guide
78-17058-01
Chapter28 Configuring Network Securi ty with ACLs Understanding ACLs
•When a VLAN map, input router ACL, and input port ACL exist in an SVI, incoming packets
received on the ports to which a port ACL is applied are only filtered by the port ACL. Incoming
routed IPv4 packets received on other ports are filtered by both the VLAN map and the r outer ACL.
Other packets are filtered only by the VLAN map.
•When a VLAN map, output router ACL, and input port ACL exist in an SVI, incoming packets
received on the ports to which a port ACL is applied are only filtered by the port ACL. Outgoing
routed IPv4 packets are filtered by both the VLAN map and the router ACL. Other packets are
filtered only by the VLAN map.
If IEEE 802.1Q tunneling is configured on an interface, any IEEE 802.1Q encapsulated IPv4 packets
received on the tunnel port can be filtered by MAC ACLs, but not by IP v4 ACLs. This is because the
switch does not recognize the protocol inside the IEEE 802.1Q header. This restriction applies to rout er
ACLs, port ACLs, and VLAN maps. For more information about IEEE 802.1Q tun ne lin g, refe r
toChapter 13, “Configuring IEEE 802.1Q and Layer 2 Protocol Tunneling.”
Port ACLs
Port ACLs are ACLs that are applied to Layer 2 inte rf ace s on a s witch . Port ACLs are supported only on
physical interfaces and not on EtherChannel interfaces and can be applied only on interfaces in the
inbound direction. These access lists are supported on L ayer 2 int erfac es :
•Standard IP access lists using source addresses
•Extended IP access lists using source and destination addre sses a nd opt iona l pr otoc ol t ype
information
•MAC extended access lists using source and destination MAC addresses and optional protocol type
information
The switch examines ACLs associated with all inbound features co nfigured on a g iven inte rface and
permits or denies packet forwarding based on how the packet matches the entries in the ACL. In this way,
ACLs are used to control access to a network or to part of a network. Figure 28-1 is a n example of using
port ACLs to control access to a network when all workstations are in the same VLAN . ACLs applied at
the Layer 2 input would allow Host A to access the Human Resources network, but prevent Host B from
accessing the same network. Port ACLs can only be applied to Layer 2 interfaces in the inbound
direction.