Cisco Systems ME3400G2CSA Applying Command Macros

10-4
Cisco ME 3400 EthernetAccess Switch SoftwareConfiguration Guide
78-17058-01
Chapter10 Configuring Command Macros
Configuring Command Macros
Applying Command Macros
Beginning in privileged EXEC mode, follow these steps to apply a command m acro :
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 macro global {apply | trace}
macro-name [parameter {value}]
[parameter {value}] [parameter
{value}]
Apply each individual command defined in the macro to the switch by
entering macro global apply macro-name. Specify macro global trace
macro-name to apply and debug a macro to find any syntax or
configuration errors.
(Optional) Specify unique parameter values that are specific to the
switch. You can enter up to three keyword-value pairs. Parameter
keyword matching is case sensitive. All matching occurrences of the
keyword are replaced with the corresponding value .
Some macros might contain keywords that require a parameter value.
You can use the macro global apply macro-name? command to display
a list of any required values in the macro. If you apply a macro without
entering the keyword values, the commands are invalid and are not
applied.
Step3 macro global description text (Optional) Enter a description about the macro that is ap plied to th e
switch.
Step4 interface interface-id (Optional) Enter interface configuration mode, and specify the interface
on which to apply the macro.
Step5 no shutdown Enable the port, if necessary. By default, UNIs are disabled, and NNIs
are enabled.
Step6 default interface interface-id (Optional) Clear all configuration from the specified interface.
Step7 macro {apply | trace} macro-name
[parameter {value}] [parameter
{value}] [parameter {value}]
Apply each individual command defined in the macro to the interface by
entering macro apply macro-name. Specify macro trace macro-name
to apply and debug a macro to find any syntax or configuration errors.
(Optional) Specify unique parameter values that are specific to the
interface. You can enter up to three keyword-value pairs. Parameter
keyword matching is case sensitive. All matching occurrences of the
keyword are replaced with the corresponding value .
Some macros might contain keywords that require a parameter value.
You can use the macro apply macro-name? command to display a list
of any required values in the macro. If you apply a macro without
entering the keyword values, the commands are invalid and are not
applied.
Step8 macro description text (Optional) Enter a description about the macro that is applied t o the
interface.
Step9 end Return to privileged EXEC mode.
Step10 show parser macro description
[interface interface-id]Verify that the macro is applied to the interface.
Step11 copy running-config startup-config (Optional) Save your entries in the configuration file.