31-7
Cisco ME 3400 EthernetAccess Switch SoftwareConfiguration Guide
78-17058-01
Chapter31 Configuring EtherChannels Understanding EtherChannels
EtherChannel On Mode
EtherChannel on mode can be used to manually configure an EtherC hannel. The on mode forces a port
to join an EtherChannel without negotiations. It can be usef ul if the remote device does not support PAgP
or LACP. With the on mode, a usable EtherChannel exists only when both ends of the link are configured
in the on mode.
Note For UNIs, the only available mode is on.
Ports that are configured in the on mode in the same channel group must have compatible port
characteristics, such as speed and duplex. Ports tha t are not compatible are suspended, even though they
are configured in the on mode.
Caution You should use care when using the on mode. This is a manual configuration, and ports on both ends of
the EtherChannel must have the same configuration. If the group is misconfigured, packet loss or
spanning-tree loops can occur.
Load Balancing and Forwarding Methods
EtherChannel balances the traffic load across the links in a channel by reducing part of the binary pattern
formed from the addresses in the frame to a numerical value that selects one of the links in the channel.
EtherChannel load balancing can use MAC addresses or IP addresses, source or de stinat ion addr esse s,
or both source and destination addresses. The selected mode a pplies to all EtherChannels configured on
the switch. You configure the load balancing and forwarding method by using the port-channel
load-balance global configuration command.
With source-MAC address forwarding, when packets are forwarded to an EtherChannel, they are
distributed across the ports in the channel based on the source-MAC address of the incoming packet.
Therefore, to provide load balancing, packets from di fferent hosts use different ports in the channel, but
packets from the same host use the same port in the channel.
With destination-MAC address forwarding, when packets are forwarded to an EtherChannel, they are
distributed across the ports in the channel based on the destination-host MAC address of the incoming
packet. Therefore, packets to the same destination are forwarded over the same port, and packets to a
different destination are sent on a different port in the channel.
With source-and-destination MAC address forwarding, when packets are forwarded to an EtherChannel,
they are distributed across the ports in the channel based on both the source and destination MAC
addresses. This forwarding method, a combination source-MAC and destinati on-MAC address
forwarding methods of load distribution, can be used if it is n ot cl ear w het her so ur ce -MAC or
destination-MAC address forwarding is better suited on a particular switch. With source-an d-destination
MAC-address forwarding, packets sent from host A to host B, host A to host C, and host C to host B
could all use different ports in the channel.
With source-IP-address-based forwarding, when packets are forwarded to an EtherChannel, they are
distributed across the ports in the EtherChannel based on the source-IP address of the incoming packet.
Therefore, to provide load-balancing, packets from different IP addresses use different ports in the
channel, but packets from the same IP address u se t he s ame p ort in t he ch an nel .