32-70
Cisco ME 3400 EthernetAccess Switch SoftwareConfiguration Guide
78-17058-01
Chapter32 Configuring IP Unicast Routing
Configuring Protocol-Independent Features
detail privileged EXEC command can be useful to debug software-forwarded traffic. To enable CEF on
an interface for the software-forwarding path, use the ip route-cache cef interface configuration
command.
Caution Although the no ip route-cache cef interface configur at ion command to disable CEF on an interface is
visible in the CLI, we strongly recommend that you do not disable CEF on interfaces except for
debugging purposes.
Beginning in privileged EXEC mode, follow these steps to enable CEF globally and on an interface for
software-forwarded traffic if it has been disabled:
Configuring the Number of Equal-Cost Routing Paths
When a router has two or more routes to the same network with the same metrics, these routes can be
thought of as having an equal cost. The term parallel path is another way to see occurrences of equal-cost
routes in a routing table. If a router has two or more equal-cost paths to a network, it can use them
concurrently. Parallel paths provide redundancy in case of a circuit failure and also enable a router to
load balance packets over the available paths for more efficient use of available bandwidth.
Although the router automatically learns about and configures equal-cost routes, you can control the
maximum number of parallel paths supported by an IP routing pr otoc ol in i ts r outi ng t abl e.
Beginning in privileged EXEC mode, follow these steps to change the maximum number of parallel
paths installed in a routing table from the default:
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 ip cef Enable CEF operation.
Step3 interface interface-id Enter interface configuration mode, and specify the Layer 3
interface to configure.
Step4 no shutdown Enable the interface if necessary. By default, UNIs are di sabled
and NNIs are enabled.
Step5 ip route-cache cef Enable CEF on the interface for software-forwarded traffic.
Step6 end Return to privileged EXEC mode.
Step7 show ip cef Display the CEF status on all interfaces.
Step8 show cef linecard [detail] Display CEF-related interface information.
Step9 show cef interface [interface-id] Display detailed CEF information for all interfaces or the
specified interface.
Step10 show adjacency Display CEF adjacency table information.
Step11 copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 router {bgp | rip | ospf | eigrp} Enter router configuration mode.