32-22
Cisco ME 3400 EthernetAccess Switch SoftwareConfiguration Guide
78-17058-01
Chapter32 Configuring IP Unicast Routing
Configuring RIP
Note In general, disabling split horizon is not recommended unless you are certain that your application
requires it to properly advertise routes.
If you want to configure an interface running RIP to advertise a summarized local IP address p ool on a
network access server for dial-up clients, use the ip summary-address rip interface configuration
command.
Note If split horizon is enabled, neither autosummary nor interface IP summary addresses are advertised.
Beginning in privileged EXEC mode, follow these steps to set an interface to advertise a summarized
local IP address and to disable split horizon on the interface:
To disable IP summarization, use the no ip summary-address rip router configuration command.
In this example, the major net is 10.0.0.0. The summary address 10.2.0.0 overrides the autosummary
address of 10.0.0.0 so that 10.2.0.0 is advertised out in te rface G iga bit Eth er net po rt 2 , an d 1 0. 0.0 .0 is
not advertised. In the example, if the interface is still in Layer 2 mode (the def ault) , yo u must e nter a no
switchport interface configuration command before entering the ip address interface configuration
command.
Note If split horizon is enabled, neither autosummary nor interface summary addresse s (those configured with
the ip summary-address rip router configuration command) are advertised.
Switch(config)# router rip
Switch(config-router)# interface gi0/2
Switch(config-if)# ip address 10.1.5.1 255.255.255.0
Switch(config-if)# ip summary-address rip 10.2.0.0 255.255.0.0
Switch(config-if)# no ip split-horizon
Switch(config-if)# exit
Switch(config)# router rip
Switch(config-router)# network 10.0.0.0
Switch(config-router)# neighbor 2.2.2.2 peer-group mygroup
Switch(config-router)# end
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 interface interface-id Enter interface configuration mode, and specify the Layer 3
interface to configure.
Step3 no shutdown Enable the interface if necessary. By default, UNIs are
disabled and NNIs are enabled.
Step4 ip address ip-address subnet-mask Configure the IP address and IP subnet.
Step5 ip summary-address rip ip address ip-network mask Configure the IP address to be summarized and the IP
network mask.
Step6 no ip split horizon Disable split horizon on the interface.
Step7 end Return to privileged EXEC mode.
Step8 show ip interface interface-id Verify your entries.
Step9 copy running-config startup-config (Optional) Save your entries in the configuration file.