B-18
Cisco ME 3400 EthernetAccess Switch SoftwareConfiguration Guide
78-17058-01
AppendixB Working with the Cisco IOS File System, Configuration Files, and Software Images
Working with Software Images
This example shows how to store a startup configuration file on a server:
Switch# configure terminal
Switch(config)# ip rcmd remote-username netadmin2
Switch(config)# end
Switch# copy nvram:startup-config rcp:
Remote host[]? 172.16.101.101
Name of configuration file to write [switch2-confg]?
Write file switch2-confg on host 172.16.101.101?[confirm]
![OK]

Clearing Configuration Information

You can clear the configuration information from the startup configuration. If you reboot the swi tch with
no startup configuration, the switch enters the setup program so that you can r econfigure the switch with
all new settings.

Clearing the Startup Configuration File

To clear the contents of your startup configuration, use the erase nvram: or the erase startup-config
privileged EXEC command.
Caution You cannot restore the startup configuration file after it has been deleted.

Deleting a Stored Configuration File

To delete a saved configuration from flash memory, use the delete flash:filename privileged EXEC
command. Depending on the setting of the file prompt global configuration command, you might be
prompted for confirmation before you delete a file. By default, the switch promp ts for c onfirmation on
destructive file operations. For more information about the file prompt command, see the Cisco IOS
Command Reference for Release 12.2.
Caution You cannot restore a file after it has been deleted.
Working with Software Images
This section describes how to archive (download and upload) software image files, whi ch con tai n t he
system software, the Cisco IOS code, and the embedded device manager software.
Note Instead of using the copy privileged EXEC command or the archive tar privileged EXEC command, we
recommend using the archive download-sw and archive upload-sw privileged EXEC commands to
download and upload software image files.
You can download a switch image file from a TFTP, FTP, or RCP server to upgrade the switch software.
For information about upgrading your switch by using a TFTP server, see the release notes
You can replace the current image with the new one or keep the c ur re nt im ag e in fl ash m em ory a ft er a
download.