Cisco Systems WRVS4400NRF manual Click Save

Setting Up and Configuring the WRVS4400N Wireless-N Router	5
Configuring the VPN Settings

STEP 3 Configure the settings in the following sections of the VPN > IPSec VPN window:

•Setting Up Local Groups on page 110

•Setting Up and Configuring Remote Groups on page 111

•Setting Up IPSec on page 113

STEP 4 To configure advanced settings, click Advanced.

•Aggressive Mode—There are two types of Phase 1 exchanges: Main mode and Aggressive mode. Aggressive Mode requires half of the main mode messages to be exchanged in Phase 1 of the SA exchange. If network security is preferred, select Main mode.

•NetBIOS broadcast—Check the box to enable NetBIOS traffic to pass through the VPN tunnel. By default, WRVS4400N blocks these broadcasts.

STEP 5 Click Save.

STEP 6 To establish a connection for the current VPN tunnel, click Connect.

To break the connection, click Disconnect.

STEP 7 To view the VPN log, which shows details of each tunnel established, click View Log.

Cisco WRVS4400N Wireless-N Gigabit Security Router with VPN Administration Guide 109