Cisco Systems WRVS4400NRF manual Udp

Troubleshooting

A

STEP 3 Enter the IP Address of the server that you want the Internet users to access. For example, if the web server’s Ethernet adapter IP address is 192.168.1.100, you would enter 100 in the field provided. Then check the Enable checkbox for the entry. Consider the examples below:

Application	Start and End	Protocol	IP Address	Enable
UT	7777 to 27900	Both	192.168.1.100	X
Halflife	27015 to 27015	Both	192.168.1.105	X
PC Anywhere	5631 to 5631	UDP	192.168.1.102	X
VPN IPSEC	500 to 500	UDP	192.168.1.100	X

STEP 4 Configure as many entries as you like.

STEP 5 When you have completed the configuration, click Save Settings.

I forgot my password or the password prompt always appears when saving settings to the router.

Reset the router to factory defaults by pressing the Reset button for ten seconds and then releasing it. If you are still getting prompted for a password when saving settings, then perform the following steps:

STEP 1 Access the router’s web interface by going to http://192.168.1.1 or the IP address of the router. Enter the default password admin, and click Administration > Management.

STEP 2 Enter the old password in the Old Password field.

STEP 3 Enter a different password in the New Password field, and enter the new password in the Confirm New Password field to confirm the password.

STEP 4 Click Save Settings.

Cisco WRVS4400N Wireless-N Gigabit Security Router with VPN Administration Guide 185