D-Link DES-3018 manual ParametersDescription Profile ID Mode Access ID Type Offset

DES-3010F/DES-3010FL/DES-3010G/DES-3016/DES-3018/DES-3026 Fast Ethernet Switch Manual

To remove a previously created rule, select it and click the button. To add a new Access Rule, click the Add button:

Figure 9- 14. CPU Interface Filtering Rule Configuration - Packet Content

To set the Access Rule for Packet Content, adjust the following parameters and click Apply.

ParametersDescription

Profile ID

Mode

Access ID

Type

Offset

This is the identifier number for this profile set.

Select Permit to specify that the packets that match the access profile are forwarded by the Switch, according to any additional rule added (see below).

Select Deny to specify that packets that match the access profile are not forwarded by the Switch and will be filtered.

Type in a unique identifier number for this access. This value can be set from 1 - 5.

Selected profile based on Ethernet (MAC Address), IP address or Packet Content.

•Ethernet instructs the Switch to examine the layer 2 part of each packet header.

•IP instructs the Switch to examine the IP address in each frame's header.

•Packet Content Mask instructs the Switch to examine the packet header.

This field will instruct the Switch to mask the packet header beginning with the offset value specified:

•value (0-15)- Enter a value in hex form to mask the packet from the beginning of the packet to the 15th byte.

•value (16-31)- Enter a value in hex form to mask the packet from byte 16 to byte 31.

131