Igmp Snooping Group | D-Link DES-3018 specification

DES-3010F/DES-3010FL/DES-3010G/DES-3016/DES-3018/DES-3026 Fast Ethernet Switch Manual

IGMP Snooping Group

This window allows the Switch’s IGMP Snooping Group Table to be viewed. IGMP Snooping allows the Switch to read the Multicast Group IP address and the corresponding MAC address from IGMP packets that pass through the Switch. The number of IGMP reports that were snooped is displayed in the Reports field.

To view the IGMP Snooping Group Table, click Monitoring > IGMP Snooping Group

Figure 11- 19. IGMP Snooping Group Table

The user may search the IGMP Snooping Group Table by VID by entering it in the top left hand corner and clicking Search.

The following field can be viewed:

ParameterDescription

VLAN ID

Multicast Group

MAC Address

Reports

Port Map

The VLAN ID of the multicast group.

The IP address of the multicast group.

The MAC address of the multicast group.

The total number of reports received for this group.

These are the ports where the IGMP packets were snooped are displayed.

NOTE: To configure IGMP snooping for the Switch, go to the L2 Features folder and select IGMP Snooping. Configuration and other information concerning IGMP snooping may be found in Section 7 of this manual under IGMP Snooping.

184

Image 197

D-Link DES-3018 manual Igmp Snooping Group, Multicast Group MAC Address Reports Port Map

Contents

Manual Copyright 2008. All rights reserved Table of Contents Snmp Manager Introduction to Web-based Switch ConfigurationAdministration Tool Tips L2 Features Security 133 CoS 109CPU Interface Filtering 122 Monitoring 165 Appendix C 204 Appendix a 200 Appendix B 203Appendix D 209 Glossary 210 Preface Typographical Conventions Intended ReadersBold font ConventionDescription Safety Cautions Safety Instructions General Precautions for Rack-Mountable Products Protecting Against Electrostatic Discharge Introduction Switch DescriptionFeatures If MIB Ethernet Technology Switching TechnologyFast Ethernet Gigabit Ethernet TechnologyPage DES-3010F Front Panel Front-Panel Components and LED Indicators LED or Button Power Console Link/Act Speed Description DES-3026 LED indicators Side Panel Description Rear panels of these switches contain an AC power connectorRear Panel Description Before You Connect to the Network InstallationPackage Contents Installing the Switch in a Rack Installing the Switch without the RackMounting the Switch in a Standard 19 Rack Power On DEM-301T Optional Module Optional Modules Optional Module Slots Upgraded DES-3018 / DES-3026 are now ready for use Switch to End Node Connecting the Switch Switch connected to switch using fiber-optic cabling Switch to Hub or Switch Uplink Connection to a server, PC or switch stack Command Line Console Interface through the Serial Port Introduction to Switch ManagementManagement Options Web-based Management Interface To connect a terminal to the console port Initial screen, first time connecting to the Switch First Time Connecting to the Switch Snmp Settings Password Protection MIBs Traps IP Address Assignment Show switch command Assigning the Switch an IP Address Connecting Devices to the Switch Logging on to the Web Manager Introduction to Web-based Switch ConfigurationIntroduction Areas of the User Interface Web-based User Interface Area AreaArea Function Web Pages Administration Device Information screen Device Information Parameter Description IP Address Click Apply to implement changes made Setting the Switchs IP Address using the Console Interface Port Settings Port Configuration Click Apply to implement the new settings on the Switch Following parameters can be configuredParameter Description State Speed/Duplex Port Description Port Description Setting and Port Description Table Following information can be viewed in the preceding window Port Error DisabledPort Connection User Accounts window User Accounts User Account Management Admin and User PrivilegesManagement Admin User Cable Diagnostics Password Encryption 12. Port Mirroring window Port Mirroring Following parameters can be set System Log SettingsParameter Description Index1-4 Host IP Severity Facility Numerical Facility Code UDP Port 514 or Status Time Settings Sntp SettingsParameterDescription Time Settings Current Time Time Source Time Settings Set Current Time Year Month Day Time in HH MM SS Time Zone and DSTClick Apply to implement your changes DST Annual Settings DST Repeating Settings Following parameters may be viewed and modified MAC Notification SettingsGlobal Settings Test Tftp ServicesPing Test MIBs Snmp SettingsSnmp Manager Snmp User Table Snmp Trap SettingsFollowing parameters are displayed ParameterDescription User Name Group Name Snmp Version Auth-Protocol Priv-Protocol Following parameters can set Snmp View Table Snmp View TableParameterDescription View Name Subtree OID View Type Snmp Group TableManager Snmp Group Table 28. Snmp Group Table Configuration Add window Snmp Community Table ParameterDescription Community Name View Name Access Right Snmp Host Table Use the Snmp Host Table to set up Snmp trap recipients Snmp Engine ID 31. Snmp Engine ID Configuration window IP-MAC-Port Binding Impb IP-MAC-Port Binding Impb 32. IP-MAC Binding Ports window IP-MAC Binding Table 33. IP-MAC Binding Table menu IP-MAC Binding Blocked IP-MAC Binding Blocked Single IP Management SIM Overview Link Single IP Management Single IP Settings SIM Settings SIM Using the Web Interface ParameterDescription Device Name Local Port TopologyHoldtime Icon Description Speed Remote Port MAC Address Model Name 39. Device Information Utilizing the Tool Tip Tool Tips 40. Port Speed Utilizing the Tool Tip Following options may appear for the user to configure Commander Switch IconRight Click Group Icon 44. Property window Member Switch Icon 46. Property window Candidate Switch Icon This window holds the following information Menu BarClick Close to close the Property window Five menus on the menu bar are as follows Device Configuration File Backup/Restore Firmware UpgradeIP Setting Upload Log File Upload Log File 55. Upload Log File window Unicast Forwarding Forwarding & FilteringUnicast Forwarding ParameterDescription Multicast Forwarding Multicast MAC Address Port Settings 59. Configure Multicast Filtering Mode Multicast Filtering Mode Smtp Service Smtp Server Settings ParameterDescription Subject Content Smtp Service Following fields can be set DHCP/BOOTP RelayDHCP/BOOTP Relay Global Settings Dhcp Relay Agent Information Option State Check Policy Click Apply to implement any changes that have been made Implementation of Dhcp Information Option 82 on the Switch DHCP/BOOTP Relay Interface SettingsRelay Interface Settings Circuit ID sub-option format Following parameters may be configured or viewed Dhcp Relay Option 60 Default SettingsRelay Option 60 Default Settings ParameterDescription Relay IP Address Mode ParameterDescription String Server IP Match Type Dhcp Relay Option 60 SettingsFollowing parameters may be configured Dhcp Relay Option 61 Settings Dhcp Relay Option 61 Default SettingsFollowing parameters may be set ParameterDescription Client ID Relay Rule VLANs L2 FeaturesVlan Description Ieee 802.1Q VLANs Ieee 802.1Q Packet Forwarding 802.1Q Vlan Tags Ingress Filtering Tagging and Untagging Switch Ports Default VLANsVlan Segmentation Vlan and Trunk Groups 1Q Static VLANs window Static Vlan Entry 1Q Static VLANs Modify Vlan Name Port Settings Tag None Egress Understanding Port Trunk Groups Link AggregationPage Parameter Description Vlan Trunk Status From…To Vlan Trunk Settings Trunking Link Aggregation Link Aggregation Lacp Port Settings Lacp Port Settings Click Apply to implement changes made 12. Current Igmp Snooping Group Entries Igmp Snooping Vlan ID Following parameters may be viewed or modified Vlan Name Member Ports Static Router Ports Settings Igmp Snooping Igmp Access Control Settings Igmp Access Control SettingsClick Apply to implement the new settings ParameterDescription From…To Status 802.1w Rapid Spanning Tree Spanning TreePort Transition States 802.1w Rstp 802.1D STP Forwarding Learning Edge Port STP Bridge Global SettingsP2P Port 802.1D and 802.1w Compatibility Spanning Tree Protocol 17. STP Bridge Global Settings 104 STP can be set up on a port per port basis STP Port Settings Priority From/ToMigration Edge Loopback Detection Following fields may be configuredLoopback Detection ParameterDescription Loopdetect Status Interval Recover Time From… To State Ieee 802.1p Priority CoSCoS Advantages of CoS An Example of the Default CoS Mapping on the Switch Understanding CoS Port Bandwidth Bandwidth Settings and Port Bandwidth Table window ParameterDescription From/To Type No Limit Rate 1p Default Priority and the 802.1p Default Priority window 802.1p Default Priority CoS Scheduling Mechanism 802.1p User PriorityScheduling Mechanism has the following parameters ParameterDescription Strict ParameterDescription Weights Weight fairCoS Output Scheduling Click Apply to let your changes take effect Priority Setting Priority Settings ParameterDescription From/To MainSelect TOS Priority SettingsConfigure the following Priority Setting parameters Dscp Priority Setting Dscp Priority Settings 10. Port Mapping Priority CoS Port Mapping Priority Settings 11. MAC Priority Setting MAC Priority Settings CPU Interface Filtering CPU Interface Filtering State SettingsCPU Interface Filtering Table Interface Filtering CPU Interface Filtering State Source MAC Profile IDDestination MAC 802.1p Source IP Mask Destination IP Mask Ethernet type Protocol Click Apply to set this entry in the Switch’s memory Parameter Description Profile ID Type Offset Shown below is the Packet Content Mask configuration window CPU Interface Filtering Table Ethernet Parameters Description Access ID 10. CPU Interface Filtering Rule Table IP Parameter Description Profile ID Mode Access ID Type 12. CPU Interface Filtering Rule Display IP Vlan Name Source IP Destination IP DSCP0-63 Port ParametersDescription Profile ID Mode Access ID Type Offset 15. CPU Interface Filtering Rule Display Packet Content Traffic Control Security Traffic Control Settings window Click Apply to implement the settings of each field 136 Port Security Port Security Settings and Table window Admin State Max. Addr0-10 Lock Address Mode Delete Port Lock EntriesLock Entries 802.1X 802.1X Port-Based and MAC-Based Access Control Authenticator Authentication Server Client Client 802.1X Authentication Process Authentication Process 10. Example of Typical Port-Based Configuration Port-Based Network Access Control 11. Example of Typical MAC-Based Configuration MAC-Based Network Access Control 12 .1X Authenticator Settings window 802.1X Authenticator Settings This screen allows you to set the following parameters ServerTimeout SuppTimeoutMaxReq ReAuthPeriod Local Users Settings to view the following window 802.1X Capability SettingsClick Security 802.1X 802.1X Capability ParameterDescription From and To Capability Guest VLANs Limitations Using the Guest Vlan Port List Configure 802.1X Guest VlanOperation 18. Initialize Port window Initializing Ports for Port Based Initializing Ports for MAC Based Reauthenticate Ports for Port Based Ports Reauthenticate Ports for MAC-basedParameter Description Port Auth State Radius Server To view the Trusted Host table, click Security Trusted Host Trusted Host 24. Current Traffic Segmentation Table Traffic Segmentation Secure Shell SSH 25. Setup Forwarding Ports window SSH Server Configuration Following algorithms may be set SSH Authentication Mode and Algorithm SettingsAlgorithm Settings Cast128-CBC Twofish128 Twofish192 Twofish256 Blow-fish CBCEncryption Algorithm Data Integrity Algorithm 28. SSH User Authentication Mode window SSH User Authentication Mode Parameter Description User Name Auth. ModeUser may set the following parameters CPU Utilization Monitoring Port Utilization window Port Utilization ParameterDescription Time Interval Record Number Received RX PacketsReceived RX Rx Packets Analysis Table Following fields may be set or viewed Packets UMB CastRX UMB Cast RX 171 TransmittedTX Transmitted TX Tx Packets Analysis window table for Bytes and Packets Rx Error Analysis window line graph Packet Errors 10. Rx Error Analysis window table 11. Tx Error Analysis window line graph 12. Tx Error Analysis window table Packet Size Packet Size Following fields can be set or viewed 15. Vlan Status window Vlan Status MAC Address MAC AddressFollowing fields can be viewed or set ParameterDescription Vlan Name MAC Address Port Find ParameterDescription Sequence Time Log Text Switch Log ParameterDescription Log Mode Time Interval Log Settings Multicast Group MAC Address Reports Port Map Igmp Snooping Group Session Table Browse Router PortBrowse ARP Table Radius Authentication Port Access ControlRadius Authentication ParameterDescription Server 187 Accounting Radius Accounting BadAuthenticators UnknownTypes PacketsDropped Auth Diagnostics EapLogOffsConnecting EntersConnectingEntersAuthenticating SuccessAuthenticating ResponsesFromSupplicant AuthSuccesses AuthFails Auth Session Statistics Auth Statistics 27. Authenticator Statistics window Rx Invalid Rx Error Last Version Last Source Auth State Monitoring Port Access Control Auth State 29. Authenticator State window MAC-Based 30. Factory Reset to Default Value window Reset Save Changes Reboot SystemFollowing menu is used to restart the Switch Logout 33. Reboot System window Physical and Environmental Appendix a CSMA/CD General Performance Appendix 1- 2. The standard RJ-45 pin assignments Appendix B System Log Entries Appendix C 205 206 207 208 Standard Media Type Maximum Distance Appendix DCable Lengths Glossary Page Warranties and Registration Limited Warranty What Is Not Covered Copyright Statement FCC WarningTrademarks Page Page Product Registration Technical Support Tech Support Technical Support Technische Unterstützung Assistance technique Asistencia Técnica Supporto tecnico Technical Support Pomoc techniczna Technická podpora Technikai Támogatás Teknisk Support Teknisk Support Teknistä tukea asiakkaille Suomessa Teknisk Support Suporte Técnico Τεχνική Υποστήριξη Tehnička podrška Tehnična podpora Suport tehnica Technical Support Technical Support Техническая поддержка Asistencia Técnica Suporte Técnico Link友訊科技台灣分公司技術支援資訊 Dukungan Teknis 技术支持 Germany Spain Egypt International Offices All Countries and Regions excluding USA Registration Card 247