D-Link DES-3018 manual Use the Snmp Host Table to set up Snmp trap recipients

DES-3010F/DES-3010FL/DES-3010G/DES-3016/DES-3018/DES-3026 Fast Ethernet Switch Manual

SNMP Host Table

Use the SNMP Host Table to set up SNMP trap recipients.

To view the SNMP Host Table window click Administration > SNMP Manager > SNMP Host Table

Figure 6- 30. SNMP Host Table

To delete an existing SNMP Host Table entry, click the corresponding button under the Delete heading. To add a new entry to the Switch's SNMP Host Table, click the Add button in the upper left-hand corner of the page. This will open the SNMP Host Table Configuration page, as shown below.

Figure 6- 30. SNMP Host Table Configuration window

The following parameters can set:

ParameterDescription

Host IP Address

SNMP Version

Community String or SNMP V3 User Name

Type the IP address of the remote management station that will serve as the SNMP host for the Switch.

V1 - To specifies that SNMP version 1 will be used.

V2 - To specify that SNMP version 2 will be used.

V3-NoAuth-NoPriv- To specify that the SNMP version 3 will be used, with a NoAuth- NoPriv security level.

V3-Auth-NoPriv- To specify that the SNMP version 3 will be used, with an Auth-NoPriv security level.

V3-Auth-Priv- To specify that the SNMP version 3 will be used, with an Auth-Priv security level.

Type in the community string or SNMP V3 user name as appropriate.

To implement your new settings, click Apply. To return to the SNMP Host Table, click the Show All SNMP Host Table Entries link.

53