•The maximum number of untransmitted mail messages placed in the queue cannot exceed 30 messages. Any new messages will be discarded if the queue is full.
•If the initial message sent to a mail recipient is not delivered, it will be placed in the waiting queue until its place in the queue has been reached, and then another attempt to transmit the message is made.
•There is a maximum of three attempts to deliver mail to recipients. Mail message delivery attempts will be tried every five minutes until the maximum number of attempts is reached. Once reached and the message has not been successfully delivered, the message will be dropped and not received by the mail recipient.
If the Switch shuts down or reboots, mail messages in the waiting queue will be lost.
SMTP Server Settings
The following window is used to configure the fields to set up the SMTP server for the switch, along with setting
Figure 6- 60. SMTP Service Settings and Mail Receiver Address Table window
The following parameters can be set:
ParameterDescription
SMTP State
SMTP Server Address
SMTP Server Port
Self Mail Address
Mail Receiver Address
Use the
Enter the IP address of the SMTP server on a remote device. This will be the device that sends out the mail for you.
Enter the virtual port number that the Switch will connect with on the SMTP server. The common port number for SMTP is 25, yet a value between 1 and 65535 can be chosen.
Enter the
Enter a list of
addresses from the Switch, click it’s corresponding 
under the Delete heading in the Mail Receiver Address Table.
Click Apply to implement changes made.
76
