D-Link DFE-2600 manual Boot Configuration File

Dual-Speed Stackable Hub Web-based Management User’s Guide

Takes string as the System Contact, corresponding to the SNMP MIB-

II object sysContact. This field is used to give the name and contact in- formation of the person responsible for the hub. The string can be up to 64 characters long.

♦syslocation string

Takes string as the System Location, corresponding to the SNMP MIB-II object sysLocation. This field is used to indicate the physical lo- cation of the hub for administrative purposes. The string can be up to 64 characters long.

♦baud-rate n

Sets the serial port communication rate used when the port is being used in out-of-band mode. Legal values for the parameter n are: 2400, 4800, 9600, and 19200.

♦2600h-image string

Takes string (which may be up to 64 characters long) as the filename of the image file to be downloaded from the TFTP server. When the hub boots, it will load the given image file from the server and execute it.

This command may be used to update the hub software when a new version is available from D-Link.

♦ip-netmask mask

Uses mask as the network mask for the local network. For a Class C network with no subnetting, the netmask should be 255.255.255.0.

♦ip-default address

Uses address as the hub default gateway address. The address should be in the form xxx.xxx.xxx.xxx, where each xxx is a number be- tween 0 and 255.

116 Boot Configuration File