D-Link DFE-2600 manual Module Installation, Making Connections

Dual-Speed Stackable Hubs User’s Guide

Module Installation

The installation procedure for each module is the same. Additional informa- tion about each module is provided below.

To install any of the modules:

1. Locate one of the module slots in the hub rear panel. (Note that the DFE-260S module can only be installed in Slot 1 - the center slot.)

2.Using a screwdriver, undo the two screws and remove the dust cover on the module slot.

3.Holding the module component-side up and connector-side in, gently slide the module along the guides and seat it in the internal connector.

4.Using a screwdriver, replace the two screws and tighten until snug.

We recommend that you retain the dust cover in case you need to remove the module for an extended period sometime in the future.

30 Making Connections