D-Link DFE-2600 manual Snmp Information, Tftp only

♦Boot Server IP Address. This variable is the IP address of the TFTP server where the configuration file is located. This entry is used only if the S/W Update Control is enabled and your boot protocol is TFTP only; if you are using BOOTP&TFTP mode, or if Send BOOTP Re- quest on Power Up is enabled, the address will be obtained from the BOOTP server.

♦Boot File Name. The pathname of the configuration file on your TFTP server. If you are using D-View as your TFTP server, this is the pathname of the .CFG file on your hard disk. This entry is used only if your boot protocol is TFTP ONLY; if you are using BOOTP&TFTP mode, or if Use BOOTP to get IP after start up is en- abled, the pathname will be obtained from the BOOTP server. For more information about the DFE-2600 series master hub configuration file, see Appendix C, Boot Configuration File.

DFE-2600 Stackable Hub - Software Update Menu

Software Update	<Disable>
Software Update Mode	<Network	>
Boot Protocol	<TFTP ONLY >
Boot Server IP Address	[210.68.85.36		]
Boot File Name	[c:\dfe2600i.cfg		]
Last Boot Server IP Address:	210.68.85.35

HELP SAVE EXIT

SNMP Information

The System Configuration Menu screen shows a variety of information about your hub, and allows you to set the System Name, System Location, and System Contact. These settings can be retrieved from the hub using SNMP

Master Hub Setup and Management 49