
(including TCP/IP parameters, SNMP parameters, the enabled/disabled set- tings of ports, etc.) will be erased and restored to their factory default settings.
1.Choose Factory Reset NVRAM to Default Value from the main menu. A confirmation message similar to that for the System Reset will appear.
2.Move the cursor to Yes to confirm the reset and press <Enter>. After a few seconds delay, the hub should restart, and all of its parameters will revert to their default values.
Note: | Doing a factory reset to the Primary Master al- |
| so resets the Backup Master variables except |
| for the the Backup Master IP address. |
|
|
|
|
70 | Master Hub Setup and Management |