Hub ID | Bridge Present | Bridge Status |
1 | Bridge | Enable |
2 | N/A | Disable |
3 | N/A | Disable |
5 | N/A | Disable |
EXIT
Resetting the Hub
You can use the console program to reset the hub stack, either doing a system reset (which restarts the hubs and is identical to powering them off and back on again) or a factory reset (which resets the master hub, reverts all of its parameters back to their factory default values, and restarts the entire hub stack).
Important Note: | If it is necessary for you to |
| the hub (or hub stack) and then re- |
| start it instead of using the reset |
| functions, the hub MUST BE |
| |
| TEN SECONDS. |
|
|
|
|
68 | Master Hub Setup and Management |
