D-Link DFE-2600 manual Software Update on Boot, Master Hub Setup and Management

Dual-Speed Stackable Hubs User’s Guide

DFE-2600 Stackable Hub - Out-of-Band/Console Setting Menu

Out-of-Band Setting		Console Setting:
Protocol:	SLIP
Baud Rate:	9600	Baud Rate:		9600
Character Size:	8	Character Size:		8
Stop Bit:	1	Stop Bit:		1
System Restart Out-of-Band Baud Rate
<9600 >
Out-of-Band Dial Up Phone Number
[	]
Current Serial	Port Setting:	Console
System Restart	Serial Port Setting <Console			>
		HELP	SAVE	EXIT

Software Update on Boot

The hub is capable of obtaining its boot-time configuration information, as well as updated versions of its internal firmware, using TFTP (the Trivial File Transfer Protocol) and BOOTP (the BOOTstrap Protocol). You can use the Software Update menu to control this feature.

The fields you can set on this menu are:

♦Software Update. This parameter determines whether or not the hub will try to look for the configuration file over the network. If set to Disable, the parameters below become irrelevant.

♦Software Update Mode. This variable can be set to either Network or Out-of-band. Determines whether the configuration file should be obtained through the Ethernet network or through the console port.

♦Boot Protocol. This parameter can be set to either TFTP ONLY or BOOTP&TFTP. Applies only if the S/W Update control is enabled.

48 Master Hub Setup and Management