10Replace the expansion card. See "Installing an Expansion Card" on page 113.

11Close the system. See "Closing the System" on page 85.

12Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

iDRAC6 Express Card (Optional)

Installing an iDRAC6 Express Card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2Open the system. See "Opening the System" on page 83.

3If installed, remove all expansion cards from expansion-card riser. "Removing an Expansion Card" on page 115.

4Insert the notch on the iDRAC6 Express card into the clip on the system board.

5Align the front edge of the card with the connector on the system board. See Figure 6-1 for the location of the connector.

6Press the card down until it is fully seated. See Figure 3-20.

When the front of the card is fully seated, the plastic standoff tab snaps over the edge of the holder.

122

Installing System Components

Page 122
Image 122
Dell R515 owner manual IDRAC6 Express Card Optional, Installing an iDRAC6 Express Card, 122