Figure 3-23. Removing and Installing the Heat Sink

1

2

1 heat sink

2

retention screws (4)

10Rotate the processor shield upward and out of the way. See Figure 3-24.

11Lift the processor out of the socket and leave the release lever up so that the socket is ready for the new processor.

CAUTION: Be careful not to bend any of the pins on the ZIF socket when removing the processor. Bending the pins can permanently damage the system board.

NOTE: In single-processor configurations, a processor must be installed in socket CPU1. Install the blank in socket CPU2 only.

130

Installing System Components

Page 130
Image 130
Dell R515 owner manual 130, Removing and Installing the Heat Sink