5Reconnect your system and peripherals to their electrical outlets, and turn on the system.

The existing passwords are not disabled (erased) until the system boots with the password jumper plug in the "disabled" position. However, before you assign a new system and/or setup password, you must return the jumper plug to the enabled position.

NOTE: If you assign a new system and/or setup password with the jumper plug still in the "disabled" position, the system disables the new password(s) the next time it boots.

6Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

7Open the system. See "Opening the System" on page 83.

8Move the password jumper back to the enabled position to restore the password function. See Table 6-1.

9Close the system. See "Closing the System" on page 85.

10Reconnect your system and peripherals to their electrical outlets, and turn on the system.

11Assign a new system and/or setup password.

To assign a new password using the System Setup program, see "System and Setup Password Features" on page 72.

Jumpers and Connectors

185

Page 185
Image 185
Dell R515 owner manual 185