Message | Causes | Corrective Actions |
|
|
|
Keyboard fuse has | Overcurrent detected at the | See "Getting Help" on |
failed | keyboard connector. | page 187. |
Local keyboard | The USB ports are disabled | Power down and restart the |
may not work | in the system BIOS. | system from the power |
because all user |
| button, and then enter the |
accessible USB |
| System Setup program to |
ports are |
| enable the USB port(s). |
disabled. |
| See "Entering the System |
If operating |
| Setup Program" on page 58. |
locally, power |
|
|
cycle the system |
|
|
and enter system |
|
|
setup program to |
|
|
change settings. |
|
|
Manufacturing | System is in manufacturing | Reboot to take the system |
mode detected | mode. | out of manufacturing mode. |
Maximum rank | Invalid memory | Ensure that the memory |
count exceeded. | configuration. The system | modules are installed in a |
The following | runs but with the specified | valid configuration. See |
DIMM has been | memory module disabled. | "General Memory Module |
disabled: x |
| Installation Guidelines" on |
|
| page 105. |
|
|
|
Memory | Invalid memory | Ensure that the memory |
Initialization | configuration. The system | modules are installed in a |
Warning: Memory | runs but with less memory | valid configuration. |
size may be | than is physically available. | See "General Memory |
reduced |
| Module |
|
| Installation Guidelines" on |
|
| page 105. |
About Your System
45
