Control Panel Assembly—LCD (Optional)

NOTE: This section applies to eight–hard-drive systems only.

NOTE: The control panel assembly consists of two separate modules—the display module and the control panel circuit board. Use the following instructions to remove and install either module.

Removing the Control Panel Display Module

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Turn off the system and attached peripherals, and disconnect the system from the electrical outlet and peripherals.

2If applicable, remove the front bezel. See "Removing the Front Bezel" on page 82.

3Open the system. See "Opening the System" on page 83.

4Disconnect the display module cable from the control panel board. See Figure 3-28.

5Using a knife or a small flat-blade screwdriver, insert the blade beneath the front panel of the display and slide the blade across the bottom to lift the panel outward. See Figure 3-28.

6Remove the front panel plate until it separates from the display module to allow access to the mounting screws.

7Remove the two screws that secure the display module to the system chassis.

8Remove the display module from the chassis cutout.

140

Installing System Components

Page 140
Image 140
Dell R515 owner manual Control Panel Assembly-LCD Optional, Removing the Control Panel Display Module, 140