Message | Causes | Corrective Actions |
|
|
|
Unable to launch | System halted after F10 | Restart the system and |
System Services | keystroke because System | update the Lifecycle |
image. System | Services image is either | Controller repository to the |
halted! | corrupted in the system | latest software to restore full |
| firmware or has been lost due | functionality. See the |
| to system board replacement. Lifecycle Controller User | |
| The optional iDRAC6 | Guide for more information. |
|
| |
| Enterprise card flash memory | Restore the flash memory |
| or BMC SPI flash may be | using the latest version on |
| corrupted. | support.dell.com. See the |
|
| Integrated Dell Remote |
|
| Access Controller 6 |
|
| (iDRAC6) User Guide for |
|
| instructions on performing a |
|
| field replacement of the |
|
| flash memory. |
|
|
|
Unexpected | Improperly seated memory | Reseat the memory modules. |
interrupt in | modules or faulty | See "Troubleshooting |
protected mode | keyboard/mouse | System Memory" on |
| controller chip. | page 165. If the problem |
|
| persists, see "Getting Help" |
|
| on page 187. |
|
|
|
Unsupported CPU | Processor(s) is not supported | Install a supported processor |
combination | by the system. | or processor combination. |
Unsupported CPU |
| See "Processors" on |
stepping | page 128. |
| |
detected |
|
Unsupported DIMM Invalid memory
detected. The configuration. The system following DIMM runs but with the specified
has been memory module disabled. disabled: x
Ensure that the memory modules are installed in a valid configuration. See "General Memory Module Installation Guidelines" on page 105.
About Your System
51
