Getting Started
Chapter 2
Introduction
G e t t i n g S t a r t e d
This chapter covers basic configuration topics. Included is information on assigning IP settings, enabling secure access with the web interface, accessing the unit through SSH, and adding or removing users.
Note: Initial setup is described in the Quick Start Guide included with the product packaging. A copy of this document is also available online at http://cm.digi.com.
Assigning IP Settings from the Console Port
The default IP address is 192.168.161.5.
The following steps use the console port to assign IP settings.
1.Connect the console port on the rear panel of the Digi CM to a serial port on a workstation using the Ethernet console cable and the appropriate Digi console adapter packaged with the Digi CM. The arrow in the following graphic points to the console port.
console port
CM 32 back panel shown
2.Configure a terminal emulation program, such as HyperTerminal, using the following settings:
•bps=9600
•data bits=8
•parity=none
•stop bits=1
•flow control=none.
3.Establish a connection to the console port and press Enter to get a command prompt.
Chapter 2 | 21 |
