Power Controller
6.Under Everyone uncheck the Access type and click Save to flash.
7.Enter the user that will have access and check the Access type.
Note: Port is access to the port. Monitor is access to sniff. Power is access to the power management.
8.Click Save to flash. Repeat steps 7 and 8 for additional users.
9.Click Save & apply after all users have been entered.
Note: The screen above shows outlets 1 & 2 control power to the Sun Server configured on port 1 of the Digi CM. Outlets 3 and 4 are not serial devices. Gilligan has been designated the specific user to control outlet # 3.
Configuring to Restrict Specific Users
To restrict specific users, you must select access for << Everyone>> and add the restricted user by deselecting his or her access.
1.Log in to the Digi CM (username root, password dbps)
2.Click Power Controller > Configuration > Outlets > Select the outlet # to configure.
3.Select the port to configure to the outlet. If it is a
4.Edit the outlet title. If there is a serial port, the port title will appear and cannot be edited from this screen.
5.Click Save & apply.
6.Check Everyone and click Save to flash.
7.Enter the username that will NOT have access, uncheck the Access types that are restricted, and click Add.
Chapter 12 | 97 |
