Dish Network 512 manual Installing or Changing the Batteries, Low Battery Warning

Remote Controls

Batteries

The remote controls come with AAA-size batteries, which need to be installed when you first receive your system. When you replace old batteries, you should replace all of the batteries. Use batteries of the same kind, for example alkaline or lithium, and don’t mix batteries of different types or kinds. Lithium batteries last longer than alkaline.

Installing or Changing the Batteries

1.Press down on the battery cover’s top latch and slide the cover off.

2.If you are changing the batteries, take out all of the old batteries.

3.Put the new batteries in. Make sure you match the plus (“+”) ends with the plus markings on the battery case.

4.Slide the battery cover back into place.

Low Battery Warning

When you see a low-battery warning message below the Program Banner, the batteries in your remote control are weak and need to be replaced.

Attach a UHF Antenna (for optional accessory)

You need to attach the UHF remote control antenna to the receiver’s back panel REMOTE ANTENNA input if you want to use an optional IR/UHF Pro remote control.

Note: Be sure to position this antenna straight up so you can use the remote control from as far away as possible. Don’t let the antenna mast touch anything.

Page 23