Safety
|
|
|
|
|
|
|
|
| Satellite Dish |
| |
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Coaxial Cable | |
| Ground Clamp |
|
|
|
|
|
|
|
| from Satellite Dish | |
|
|
|
|
|
|
|
|
| Electric Service Equipment | ||
| Antenna Discharge |
|
|
|
|
|
|
|
| Ground Clamps | |
| Unit |
|
|
|
|
|
|
|
| Power Service Grounding | |
|
|
|
|
|
|
|
|
|
| ||
Grounding Conductors |
|
|
|
|
|
|
|
| Electrode System | ||
|
|
|
|
|
|
|
| (NEC Art. 250, Part H) | |||
(NEC Section |
|
|
|
|
|
|
|
|
|
| |
Safety Tips
•Unplug the receiver from the AC power outlet before cleaning.
•Always handle the satellite receiver carefully. Excessive shock and vibration can damage the hard drive.
•Do not place the receiver in an enclosure such as a cabinet without proper ventilation. Do not stack the receiver on top of or below other electronic devices as this can cause heat
•Do not install the receiver in any area where the temperature can be less than 40°F or more than 113°F. If the receiver is cold to the touch, do not plug it in immediately. Let it sit unplugged at room temperature for at least 45 minutes before plugging it in.
•Operate the receiver using only the power source type indicated on the marking label. Unplug the receiver power cord by gripping the power plug, not the cord.
•Do not overload wall outlets or extension cords, as this can result in a risk of fire or electrical shock.
•Never insert objects of any kind into the receiver through openings, as the objects may touch dangerous voltage points or short out parts. This could cause fire or electrical shock.
•Ensure that the outdoor parts of the antenna system are grounded in accordance with local, state, federal, and National Electrical Code (NEC) requirements.
•Do not locate the antenna near overhead light or power circuits, or where it can fall into such power lines or circuits. When installing the antenna, take extreme care to avoid touching such power lines or circuits, as contact with them can be fatal.
•Do not attempt to service the receiver yourself, as opening or removing covers may expose you to dangerous voltage, and will void the Limited Warranty. Refer all servicing to authorized service personnel.
•Use an outlet that contains surge suppression or ground fault protection. For added protection during a lightning storm, or when the receiver is left unattended and unused for long periods of time, unplug the power cord from the wall outlet, disconnect the lines between the receiver and the antenna, and disconnect the telephone line. This will provide some protection against damage caused by lightning or power line surges.
On some TVs, the presence of fixed images for extended periods of time may cause them to be permanently imprinted on the screen. Consult your TV user guide for information on whether this is a problem for your TV, what operating/viewing restrictions apply to avoid this problem, and associated TV warranty coverage.
Page iv
