Optional - Connecting VCRs to the System

Optional - Connecting VCRs to the System

The diagram below provides examples of how to connect VCRs to your satellite

TV system. Your particular installation may differ from these examples.

Connecting a VCR to the Nearby TV

1.Connect a coaxial cable from the CH 3-4 OUT output on the receiver to the nearby VCR’s tuner input port.

2.Connect a coaxial cable from the output on the VCR to the nearby TV’s tuner input port.

3.Plug in and turn on the nearby VCR and TV.

4.Set the VCR output to Channel 3 or 4, as selected on page 27.

5.Tune the nearby VCR and TV to Channel 3 or 4, as selected on page 27.

6.You can place a TV1 channel sticker (Channel 3 or 4, as selected in step 5) on or near the nearby TV. This sticker will remind you which channel to use on this TV to watch satellite programming. The stickers are located in the inside front cover of this guide.

Optional - Connecting to an Over-the-Air Antenna or

Cable

If you want to receive channels from an over-the-air antenna or cable in addition to your satellite receiver programming, connect the over-the-air antenna/cable into your TV distribution equipment.

For the nearby TV receiving programming from CH 3–4 OUT, the over-the-air antenna cable needs to be connected to the TV ANTENNA/CABLE IN port.

Page 31

Page 35
Image 35
Dish Network 512 manual Optional Connecting VCRs to the System, Optional Connecting to an Over-the-Air Antenna or Cable