Chapter 2
Receiver Description and Installation
Setting Up TV1 to Operate in UHF Pro
You can set your receiver to operate TV1 using an optional IR/UHF Pro remote control (sold separately) by completing the following instructions:
If you set up your receiver to operate tuner 
using UHF Pro, any other UHF Pro remotes in the building will interfere with each other when operated at the same time. This may prevent remotes from operating the receiver momentarily.
1.Perform the following using an existing remote control:
a.Open the TV1 UHF Pro Setup screen by pressing
b.Select Enable from the TV1 UHF Pro Setup screen.
c.Select System Info to open the System Information screen.
d.Move the highlight to the address for the Primary Remote Address as shown below.
Note: Highlight the
Primary Remote
Address.
2.Perform the following steps using the UHF Pro remote that you are going to use to control TV1:
a.Press and hold the SAT mode button about three seconds, until all the mode buttons light up, and then release the SAT button. The SAT mode button begins to blink.
b.Use the NUMBER PAD buttons to enter any number from 1 to 16. The SAT mode button goes blinks as you enter each digit, then remains lit. Write down the number you entered:
c.Press the POUND (#) button. If you entered the address correctly, the SAT mode button will flash three times.
d.Press the RECORD button.
e.Make sure the System Information screen shows that the Primary Remote Address indicates 
UHF Pro and IR, and that this address matches the number that you wrote down in step b.
Page 34
