Dish Network Solo 351 manual You expect

Chapter 5

Reference

What Is Happening		Possible Reason	What to Do
You set up an event timer,	•	The program time may have	• If the receiver is ON and finds an event timer overlap, it will
but the timer does not		changed so that the event timer	display the Event Timer Scheduling Conflict menu. You
operate at all.		overlapped another event timer.	must edit or delete one of the overlapping event timers.
		The program time may have	No event timer will operate if the program time changes by more
		changed by more than twenty-four	than twenty-four hours.
		hours.
You set up a Once event	•	The program time changed.	• A Once event timer always operates at the actual time of the
timer, but the timer operates			program.
at a time different from what
you expect.
You stop the operation of an	•	Stopping the event timer applies	• To stop all operations of a repeated event timer, you must delete
event timer for one showing		only to the current showing of the	the event timer.
of a program that is repeated		program.	Note: The receiver deletes a Once event timer when it operates.
(such as a regularly
scheduled program), but the
timer operates for the next
showing.
You are testing a VCR code	•	The VCR may not be turned ON,	• Make sure the VCR is turned ON, with a blank tape inserted on
to see if the receiver controls		there may not be a tape inserted,	which you want to record, that the tape is rewound, and that the
a VCR. The VCR does not		the tape may not be rewound, or the	write-protect tab on the tape is intact.
do the test.		write-protect tab on the tape may	Try another VCR code from the VCR Codes table.
		have been removed.
		The code you are testing may not
		be valid for the VCR.

Page 112