Connecting the Receiver to the TV(s) in Another Room(s)
9.If your TV is in
10.Set all of your remote TV(s) to the channel mode
11.Tune all of your remote TV(s) to the channel you wrote in the margin. This is the channel you will use to receive your satellite programming.
12.Turn on the nearby TV (the TV that gets programming from the TV1 outputs).
13.Press the POWER button on Remote Control 1 to turn on the receiver's green TV1 indicator.
14.You should now be looking at the Point Dish screen on your nearby TV. Select the Modulator Setup, if shown. If the option is not shown, press MENU
15.With the Modulator Setup screen displayed on the nearby TV, use Remote Control 1 to do the following:
a.Under TV2 Out, select either Air (for
b.Under TV2 Out, use the up and down arrow buttons to change the modulator channel to the one you wrote in the margin in step 8.
c.Select Done to save the changes.
16.Using Remote Control 2, press the POWER button and make sure the receiver's blue TV2 indicator turns on.
17.For some TVs, you must run a channel scan so that the TVs will find and display the selected channel from the receiver. Run channel scan on all remote TV(s), if available. See your TV user guide for instructions.
18.Confirm that you see a picture from the receiver TV2 output, likely the Point Dish screen, on your remote TV(s).
• If your picture looks good, go to step 26.
• If your TV(s) do not have a picture or if it is not as clear as you would like it to be, go to the next step.
Page 23