Chapter 1

Introduction

Getting Started

Tip: Remote Control 1 is used to control TV1 menus on the nearby TV. Remote Control 2 is used to control TV2 menus on the remote TV(s).

After your system has been installed, order and watch your programming using the following steps:

Step 1: Ordering Your Programming

1. Using a remote control, press SAT and then press the blank POWER button. Make sure the TV is also on.

Note: If you see the DISH Network logo displayed on your TV screen, press the SELECT or blank POWER button on the remote control to view satellite TV programming.

2.Press GUIDE.

You will see that some channels in the Program Guide appear

in white. These channels can be viewed immediately. However, many channels will be in red. You cannot view these channels until you order programming.

3.Press the SYS INFO button on the remote control to display

the Important System Information screen.

4.Call the Customer Service Center at 1-800-333-DISH (3474). A customer service representative will help you start DISH Network programming on your system and will discuss the various programming packages available.

5.Choose a package and the representative will authorize your programming.

6.Press SELECT to close the Important System Information screen.

7.Wait a few minutes and the channels you purchased will turn from red to white, and can now be viewed.

Page 4

Page 8
Image 8
Dish Network Solo 351 manual Getting Started, Ordering Your Programming