Dish Network Solo 351 manual Connecting the Receiver to the TVs in Another Rooms

Connecting the Receiver to the TV(s) in Another Room(s)

Connecting the Receiver to the TV(s) in Another

Room(s)

This section describes how to connect the receiver CH 21–69 OUT connection to the cable-ready remote TV located in another room away from the receiver. This installation uses your in-home cable system. If your house does not have built-in cabling, it will be necessary to run cables from the receiver to each remote TV. Due to the difficulty of this installation, you should consider having this professionally installed. Call DISH Network at 1-800-333-DISH (3474).

Note: When connecting to the home distribution (CH 21–69 OUT) coaxial port, you must meet the FCC requirements in the Appendix. To meet these requirements, an in-line coaxial attenuator has been included with your receiver and may need to be installed using the following guidance:

•If connecting to your in-home cabling system to distribute the signal to a TV(s) in other rooms, in most cases you will not have to install the attenuator on the CH 21–69port for typical in-home cabling systems.

•If connecting directly to a TV tuner port, you must install the attenuator in the cable between the CH 21–69 OUT port and the TV tuner.

Receiver Back Panel

Attenuator

If you have an off-air antenna or cable connected to your in- home cable system, see Optional - Connecting to an Off- Air Antenna or Cable following this section.

Page 21