Connecting to a SCSI Controller on a Low Profile PCI Card

1.Obtain a SCSI cable with an unfolded length of 26-inches.

2.Flatten the cable and fold it in half for the full length, leaving about 1-inch at each end (see Figure 32).

3.Fold the cable in half again and secure with electrical tape.

4.Connect the cable to the tape drive (see Figure 33, A) and carefully route the folded and taped section on the chassis floor between the fan assembly (C) and the tape drive (A).

5.Connect the cable to the SCSI controller (B) on the low-profile PCI card.

Figure 32: SCSI Cable Length Required

Figure 33: Connecting to a half Height PCI SCSI Controller

Installing a COM 1 port in the Rear I/O

Using a standard DH-10 to DB-9 COM cable, you may install a COM 1 port in the opening provided in the rear I/O (see Figure 3, C, on page 9). Connect the other end to the COM 1 serial port header on the server board (see Figure 4 on page 13)

Viglen SX220 User Guide

49

Page 50
Image 50
Intel SX220 manual Connecting to a Scsi Controller on a Low Profile PCI Card, Installing a COM 1 port in the Rear I/O