| The server can boot and run the operating system, but mouse and | |
| keyboard input is not accepted until the user password is entered. | |
| At boot time, if a CD is detected in the | |
| A, the system prompts for a password. When the password is entered, the | |
| server boots from CD or diskette and disables the secure mode. | |
| If there is no CD in the | |
| boots from drive C and automatically goes into secure mode. All enabled | |
| secure mode features go into effect at boot time. | |
| To leave secure mode: Enter the correct password(s). | |
Disable writing | In secure mode, the server will not boot from or write to a diskette unless a | |
to diskette | password is entered. | |
| To write protect access to diskette whether the server is in secure mode or | |
| not, use the Setup main menu, Floppy Options, and specify Floppy Access | |
| as read only. | |
Set a time out | Specify and enable an inactivity time out period of from 1 to 120 minutes. | |
period so that | If no keyboard or mouse action occurs for the specified period, attempted | |
keyboard and | ||
mouse input | keyboard and mouse input will not be accepted. | |
are not | The monitor display will go blank, and the diskette drive will be write | |
accepted | ||
Also, screen | protected (if these security features are enabled through Setup). | |
To resume activity: Enter the correct password(s). | ||
can be | ||
blanked, and |
| |
writes to |
| |
diskette can |
| |
be inhibited |
| |
Control access | To control access to setting or changing the system configuration, set a | |
to using the | supervisor password and enable it through Setup. | |
SSU: set |
| |
supervisor | If both the supervisor and user passwords are enabled, either can be used | |
password | to boot the server or enable the keyboard and/or mouse, but only the | |
| supervisor password will allow Setup to be changed. | |
| To disable a password, change it to a blank entry or press | |
| Change | |
| Password menu of the Supervisor Password Option menu found in the | |
| Security | |
| Subsystem Group. | |
| To clear the password if you cannot access Setup, change the Clear | |
| Password jumper (see Chapter 9). | |
Control access | To control access to using the system, set a user password and enable it | |
to the system | through | |
other than | Setup. | |
SSU: set user |
| |
password | To disable a password, change it to a blank entry or press | |
| Change |
24 | Viglen SX220 User Guide |