Characters Are Distorted or Incorrect, 125

Try the solutions in the order given. If you cannot correct the problem, contact your service representative or authorised dealer for help.

Power Light Does Not Light

Check the following:

Is the system operating normally? If so, the power LED is probably defective or the cable from the front panel to the server board is loose.

Are there other problems with the system? If so, check the items listed under “System Cooling Fans Do Not Rotate Properly.”

If all items are correct and problems persist, contact your service representative or authorised dealer for help.

No Characters Appear on Screen

Check the following:

Is the keyboard functioning? Check to see that the “Num Lock” light is functioning.

Is the video monitor plugged in and turned on?

Are the brightness and contrast controls on the video monitor properly adjusted?

Are the video monitor switch settings correct?

Is the video monitor signal cable properly installed?

Is the onboard video controller enabled?

If you are using an add-in video controller board, do the following:

1.Verify that the video controller board is fully seated in the server board connector.

2.Reboot the system for changes to take effect.

3.If there are still no characters on the screen after you reboot the system and POST emits a beep code, write down the beep code you hear. This information is useful for your service representative.

4.If you do not receive a beep code and characters do not appear, the video display monitor or video controller may have failed. Contact your service representative or authorised dealer for help.