Intel SX220 manual Adding Components to the Server Board, Installing Processors

Adding Components to the Server Board

After installing the server board, you must add the desired number of processors and memory DIMMs.

NOTE: Once the server board and its components are installed, you are done assembling the system unless you have optional peripherals or add-in cards you wish to install. If you need to install these components, continue on to the next section. Otherwise, install the cover and bezel and continue on to Chapter 5, “Installing the System in a Rack” found on page 51.

Installing Processors

1.Observe the safety and ESD precautions at the beginning of this chapter.

2.Raise the locking bar on the socket.

3.Observe the safety and ESD precautions at the beginning of this chapter.

4.Raise the locking bar on the socket.

Figure 16 Raising the Locking bar on the socket

5.Aligning the pins of the processor with the socket, insert the processor into the socket.

6.Lower the locking bar completely.

36 Viglen SX220 User Guide