5.Connect the end of the flex circuit cable (C) labeled to the floppy/front panel/IDE connector on the server board. Route the cable to the backplane board and connect the opposite cable end to the matching connector on the backplane.
CAUTION!
After connection of cable (C) in step 5, ensure that each cable connector is properly seated in the board connector. The connector should be parallel to its board connector and not cocked to one side. If in doubt, remove, reinsert, and recheck.
6.Locate the end of the SCSI ribbon cable (I) that is labeled baseboard. Connect that end to the SCSI connector on the server board. Route the cable to the backplane board and connect it to the matching connector on the backplane board.
7.Route the backplane power cable (A) from the power supply to the backplane board and connect it to the white
8.Connect the front panel cable (E) to the front panel board. Insert the cable in the cable clip (**), route it to the backplane, and connect it to the matching connector.
9.Connect the USB cable (F) to the USB connector on the server board. Route the cable along the chassis floor at the bottom of the chassis sidewall (*). Connect it to the front panel board.
10.Connect the system fan cables (G) to their server board connectors.
11.If you have installed a tape drive, connect the tape drive power cable (D) to the drive.
Viglen SX220 User Guide | 33 |
