Intel SX220 manual Configuration Software and Utility, Hot Keys, Configuration Utilities

6. Configuration Software and Utility

This chapter describes the Power-On Self-Test (POST) and server configuration utilities. The table below briefly describes the utilities.

Table 5: configuration Utilities

Utility	Description and brief procedure
BIOS Setup	Use for system configuration of onboard resources, setting boot device
	priority, or setting system security options.
	You can move the CMOS jumper on the system board from the default
	setting (Protect CMOS memory) to the Clear setting; this will allow most
	system configurations to boot.
Changing Boot Device Priority	Use this option to change the boot device priority temporarily
	permanently.
Adaptec SCSISelect † Utility	Use to configure or view the settings of the SCSI host adapters and
	onboard SCSI devices in the system.
Direct Platform Control (DPC)	Use to access and monitor the server remotely.
Console
System Setup Utility (SSU) And	Use for viewing and configuring server management options, viewing
Client System Setup Utility (CSSU)	the system event log (SEL), setting boot device priority, or setting
	system security options.
	The SSU can run either from the configuration software CD or from a set
	of bootable diskettes. You can create the diskettes from the CD.
	The CSSU is run from the service partition via the DPC console. It
	provides the same functionality as the SSU, but from a remote console.
	Information entered via the SSU/CSSU overrides information entered
	via BIOS Setup.
FRU/SDR Load Utility	Use to update the Field Replacement Unit (FRU) and Sensor Record
	(SDR) flash components.
	NOTE: You must run the FRU/SDR Load utility whenever BMC is
	updated or if you change your processors.
BIOS Update Utility	Use to update the BIOS or recover from a corrupted BIOS update.
Firmware Update Utility	Use to update BMC flash ROM or other firmware.

Hot Keys

Use the keyboard’s numeric pad to enter numbers and symbols.

Table 6: Hot Keys

To do this:	Press these keys
Clear memory and reload the	<Ctrl+Alt+Del>
operating system this is a system
reset.
Enter the Adaptec SCSI Utility	<Ctrl+A> (SCSI model only)
during POST.
Enter the Promise Technology IDE	<Ctrl+F> (ATA model only)
RAID Utility.
Enter BIOS Setup during POST.	<F2>
Abort memory test during POST.	<ESC> (Press while BIOS is updating memory size
	on screen.)
Display a menu for selecting the	<ESC> (Press anytime after memory check.)
boot device.

Viglen SX220 User Guide 57