Receiver Back Panel

S-Video Out

The S-VIDEOconnection provides the highest quality video available to your nearby TV (if your TV has this connection). Use an S-Video cable to make the connection. If you use this back panel output for video between your receiver and nearby TV, you must still connect the audio using the PHONO (RCA) AUDIO LEFT/RIGHT OUTPUTS and Phono (RCA) cables.

TV Antenna/Cable In

The TV ANTENNA/CABLE IN is used if you want the satellite receiver to connect the tuner of the nearby TV to an off-air antenna or cable TV system when the satellite receiver is turned off or when using the TV/VIDEO button on Remote Control 1. Use a coaxial cable to make this connection to an off-air antenna or cable TV system. The TV ANTENNA/ CABLE IN connection is color coded black. Your nearby TV must be connected to the CHANNEL 3-4output to use this feature.

TV2 Connections

The following connections provide TV2 menus and programming to the remote TVs.

Ch 21–69 OUT

The CH 21–69 OUT connection provides good quality video and mono (non-stereo) audio for the remote TV(s).

Use a coaxial cable to make this connection to your home cable system. Remote TVs connected to the home cable system can receive programming from this receiver output. The CH 21–69 OUT connection is color coded yellow.

When connecting to the home distribution (CH 21–69 OUT) coaxial port, you must meet requirements covered under FCC Compliance in the Appendix. To meet these requirements, an in- line coaxial attenuator has been included with your receiver and may need to be installed using the following guidance:

If connecting directly to a TV tuner port, you must install the attenuator in the cable between the CH 21–69 OUT port and the TV tuner.

If connecting to your in-home cabling system to distribute the signal to a TV(s) in other rooms, in most cases you will not have to install the attenuator for most in-home cabling systems.

Tip: If you connect a cable to the TV ANTENNA/CABLE IN port, attach the black sticker to the cable near where it attaches to the receiver. The stickers are located inside the front cover of this guide.

Page 15

Page 19
Image 19
Dish Network Solo 351 manual Receiver Back Panel, Video Out, TV Antenna/Cable, TV2 Connections, Ch 21-69 OUT