Connecting the Receiver to the Phone Line
4.For TV2 Out, select either Air (for
5.Highlight the number under TV2 Out.
6.Use the UP and DOWN ARROW buttons to change the modulator channel to one of the following:
•Air Mode - Select a channel between 21 and 69.
•Cable Mode - Select a channel between 73 and 125.
7.Select Done to save the changes.
8.Change the channel on your TV(s) to match the channel(s) you selected.
9.If desired to remind you of which TV channel to tune to get satellite programming, place a channel sticker near or on your TV to indicate the correct channel.
10.If you changed your TV2 Out channel, repeat Programming the Recover Button for a Remote TV.
Connecting the Receiver to the Phone Line
You must keep the receiver connected to an active telephone line. Otherwise, you may not be able to order pay per view programs or use all of the DISH Interactive features.
Note: You may be able to use a wireless telephone extender. However, this may not support all the features of this receiver, such as Caller ID.
Note: If you have a Digital Subscriber Line (DSL), you may have to install a DSL filter between the receiver’s back panel PHONE JACK and the telephone wall jack to successfully connect with the DISH Network. You can obtain a filter from your DSL provider.
Phone Line Connection
Run a telephone cable with a standard
Phone System Setup
You must also set up the receiver for your telephone system (touchtone or rotary/pulse), and set a telephone number prefix, if you need a prefix to make an outside call.
1. Display the Phone System screen by pressing
Tip: The channel stickers are located inside the front cover of this guide.
Page 27