Draytek 2750 manual Routing Table

4.14.2 Routing Table

Click Diagnostics and click Routing Table to open the web page.

Destination	Display the IP address for destination network or
	destination host.
Gateway	Display the gateway address or “*” if none set.
Genmask	Display the netmask for the destination net;
	'255.255.255.255' is for a host destination and '0.0.0.0' is
	for the default route.
Flags	Different codes represent different routing status.
	U - route is up.
	H - target is a host
	G - use gateway
	R - reinstate route for dynamic routing
	D - dynamically installed by daemon or redirect
	M - modified from routing daemon or redirect
	A - installed by addrconf
	C - cache entry
	! - reject route
Metric	Display the distance to the target (usually counted in hops).
Ref	Display number of references to this route. (Not used in the
	Linux kernel.)
Use	Display count of lookups for the route. Depending on the
	use of -F and –C, this will be either route cache misses (-F)
	or hits (-C).
Iface	Display interface to which packets for this route will be
	sent.
Refresh	Click it to reload the page.

Vigor2750 Series User’s Guide 233